Skip to main content
AEG | Help and Support

Dishwasher displays error message i60

Issue:
  • Dishwasher displays error message i60
Applies to:
  • integrated dishwasher
  • freestanding dishwasher
Resolution:

1. Reset your appliance

Remove the plug for the dishwasher, wait 1 minute and plug it back in.
You can also turn off the power using the fuses on the panel/power switch.
If you have pulled the machine out and then pushed it back into position, it is important to ensure that no tubing is kinked or crushed and that the tap is fully open.
Turn on the dishwasher, select a suitable cycle and start it.
If the cycle starts and operates normally, the problem has been resolved.
2. Check whether the appliance displays the same error message again or whether it has changed

If the appliance shows a different error code, check the code in the user manual for help troubleshooting the problem. (You can download user manual here).

3. Contact an Authorized Service Centre

If the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.